Step 1. If you're installing parting boards in the middle of the deck, start marking the joist spacing from the center of the beams working toward the end joists. Mark the first joist at 8 inches on-center, then every 16 inches on-center toward the ends. Do the same in the other direction.
Install the sleepers directly on the concrete. The old patio's surface must be solid and reasonably flat. Gravel, sand, dirt, and concrete pavers are NOT suitable materials upon which to install the sleepers and decking because the sleepers are not sturdy enough to span gaps, as with a normal raised deck.
Installing post anchor. Make sure the drill bits are in good condition, otherwise you might damage the drill machinery. Smart Tip: The drill machinery must have hammering function, otherwise you won’t be able to drill in concrete and anchor the post. Hold the drill machinery like a gun, with one hand on the holder,...
Install the deck boards just as you would on a standard deck. When you reach the end of the patio, position the last board, mark the overhanging sleepers and trim off the excess. Before decking, we covered the sleepers with flashing tape.
In the event that you interested, you will see Installing Wood Deck Over Concrete Patio. Natural home design could be the smart idea to create the surrounding to the home. This is the reason the idea looks dominated by the touch or the natural style.
hrs Existing sidewalk, slab, or driveway will be excavated with hand tools to a uniform depth (up to 8") below final surface level. Excavation material will be distributed on site. For your project in zip code 98104 with these options, the cost to install a concrete pool deck starts at $7.10-$8.60 per square foot.
Installing Deck Ledgers A ledger board is a horizontal piece of lumber attached to a wall to support the ends of deck joists. The ledger can be attached using one of three methods.
How Install Concrete Deck Footings. In this example, part of the deck frame is mounted to the foundation of the house, so measurements are made off of the end point of that frame. Two 2x6s will serve as the outer frame, and an additional 2×8 will be mounted on the outside of those boards for the finishing side piece.
For starters, any time you’re installing a deck over an existing hard surface, you’re going to need a sleeper system. 1. What Is a Sleeper System? A sleeper system is a substructure that sits between the concrete and the decking. It is comprised of joists that raise the deck slightly above the surface of the concrete.
Installing the runners Your concrete porch should already be slightly slanted away from the house in order to drain rain water away from it. This grade is good and needs to be preserved. This grade is good and needs to be preserved.