screw placement tongue groove composite deck board

How to Groove Square Edge Deck Boards - Timber Fasteners

How to Groove Square Edge Deck Boards by Anthony DiSanto, FastenMaster Decking & Trim Product Manager If you are using hidden deck fasteners, there may be occasions when you need to cut a groove into a square edge deck board.

Get Quotes

Deck Fasteners...You've Got Options | Construction Pro Tips

Upgrade to composite deck screws. ... The clip is then inserted into the side groove of a deck board and fastened to the joist with a scrail. The scrail holds as well as a ring-shank nail but can be removed like a screw if a damaged board needs to be replaced. Pretty cool system, huh? But before you get too lathered up over it, know that the ...

Get Quotes

Cedar Deck Board Spacing: Get It Wrong Pay the Price | RMFP

A 16 penny nail is not 1/8″ in diameter it is actually 5/32″. I am in the process of pulling all my deck boards because I put them to tight to begin with (1/8″), used a poor quality deck screw and then compounded the whole mess by putting on a very poor quality (SW) solid color stain although I back-primed with a clear sealant.

Get Quotes

Grooved vs Ungrooved Composite Decking ... - Learning Center

The main difference between grooved and ungrooved composite decking lies in the construction of their sides. A grooved board features a notch or channel down the edges, while a solid board is groove-free. This does not substantially impact your deck’s overall look, but it does change how you install the decking. Finishing and Fasteners

Get Quotes

Installing GeoDeck Tongue & Groove with Ballistic NailScrews

Quick and easy installation of GeoDeck Tongue and Groove decking with UFO Ballistic NailScrews. Drive them in; Screw them out! ... Quick and easy installation of GeoDeck Tongue and Groove decking ...

Get Quotes

I.Dekk Composite Decking | Residential PVC Decking | Green ...

Use genuine Green Bay Decking fasteners, or equivalent. All fasteners must be located a minimum of 3/4” from the ends of the deck boards. Additionally, any necessary face fasteners should be placed near the deck board structural septum, but not directly through the septum. Avoid over penetration of the fastener heads.

Get Quotes

Can I Use Tongue and Groove Boards for Decking? - ...

This sinking action will allow the next deck board to slide into place and will perfectly conceal the previously installed screw head. Some helpful tips to remember when using tongue and groove lumber for decking: You must have 24” or more of open air space below the deck to use tongue and groove boards.

Get Quotes

Waterproof Decking | Professional Deck Builder ...

The boards simply push together, compressing the seal, and then standard deck screws are installed through the screw ledge (on the groove side of the profile). The screws are hidden by the next board and remain dry their entire life. There are no special end caps to install, and because the boards have a solid core, no water can get trapped ...

Get Quotes

Low-Maintenance Decks | Family Handyman

The tongue-and-groove style looks tight and clean (no fasteners) and partially protects the space beneath from rain. The lighter weight boards are easier to handle and are often more suitable for rooftop decks. Some tongue-and-groove versions fit tightly and look more like a porch floor than a deck. guys decking

Get Quotes

screw placement grooved composite deck boards

composite deck boards - InspectAPedia Using Composite Decking: Synthetic or "Plastic" Deck Boards Most composite decking can be attached with standard deck screws or nails. Webbed, or hollow-core, composite decking is available in both rectangular and tongue-and- groove With Webbed decking, fastener placement can be particularly important .

Get Quotes

Product Details

Product List