Use a specific drill that will drill a neat hole into the concrete base. Once the hole is drilled, you can then attach the stringers with the bolts. Step 3 - Attach Stringers to Concrete. Concrete is either the base underneath the stringer or it may also be a concrete footing that you have poured to provide extra support and strength to your stairway.
attaching our to concrete Fine Homebuilding Breaktime . attaching our to concrete . attaching our to concrete post mick meyers on Tue, 04/07/2015 - 16:29 . in . Construction Techniques; Here is a hidden decking clip, can be screwed to the concrete exactly the same as the joists.
Anchoring Deck Stairs. With frost footings in place you can use a concrete anchor, base plate and short post in order to create a solid ground connection. A 3' x 3' level landing area is required at the base of all staircases. The ground may qualify if it meets the requirements. Use your jigsaw.
You'll be attaching the pressure-treated 2-by-4s across the width of the concrete every 16 inches as deck sleepers to support the composite decking. Measure the width of the concrete with a tape measure, and then cut the boards to length using a table saw.
Step 3. Remove the bolts from the sleeves and slide the sleeves into the holes in the concrete. Set the kick-plate in position and use a wrench to tighten the hex heads of the bolts into the sleeves, affixing the kick-plate onto the concrete.
deep and a rise from grade to deck surface of 5 ft. That’s 20 sq. ft. and a total load of 1000 lb. Half of this load is borne by the footing at the bottom, which leaves a 500-lb. load at the top. Adding that load from the stairs to an end joist sized for the deck load only will overload that joist.
Decks installed over concrete porches or patios aren’t all that common. One reason is that on most homes with concrete patios there isn’t much space to build a deck. Concrete patios are normally found on homes with concrete slab foundations, and the thresholds of the exterior doors are generally very close to the ground, usually three to four inches.
Attaching Stairs to a Deck. The final stage in building your deck is likely going to be when you connect the stairs to the deck. Every set of stairs has to be connected to the deck somehow. It is not always done the same way. Here are the various ways in which you can attach them and it is dependent on joist direction or the style of the stairs.
It is possible to install Latitudes decking over a concrete patio.[...Online Service] sdi manual of construction with steel deck - Steel Deck Institute. Sheet to sheet fastening is done with screws, button punching. (crimping), or welds. 2. ... to mechanically lock the concrete and deck together so that the concrete and the deck ...
How to calculate, lay out, saw, and attach a set of treated pine steps to a concrete porch.
Attaching the Ledger Board to a Concrete Wall - Decks Step by step instructions on how to install a deck ledger board to a concrete house foundation wall using expansion anchors. Deck Can Be Built Over Concrete Patio Using Frame Base ...